Evinrude Outboard Fitment Specification
Evinrude E-TEC 115 HP (V4) Propeller Slip & Fitment Guide
Dialing in a Evinrude E-TEC 115 HP (V4) starts with its factory 2.00:1 lower-unit gear ratio and 5,500 – 6,000 RPM wide-open-throttle ceiling. Launch SlipStream below with these exact factory specs pre-loaded to measure your current slip percentage and compare gearcase-matched stainless upgrades.
Gear Ratio
2.00:1
Factory WOT RPM
5,500 – 6,000 RPM
Gearcase & Spline
4.25" · 13-Spline
Diameter Class
13"–13.5"
Typical Pitch Range
13" – 21"
Matched Hub Kit
4.25" 13-Spline Intermediate Hub Kit (Evinrude V4)
Recommended Stainless Prop Architectures for Evinrude E-TEC 115 HP (V4)
Holeshot, Heavy Load & Bay Cruise (4-Blade)
Turning Point Express Mach4 (4.25" · 13.25" dia) or Solas Rubex HR4 Titan
Adds stern lift, reduces slip in turns, and holds plane at lower speeds—drop 1" of pitch when stepping up from a 3-blade wheel.
Top-End Speed & Light Skiff (3-Blade)
Solas Rubex NS3 (4.25" · 13.25" dia) or Turning Point Express Mach3
High-rake 3-blade stainless geometry maximizes bow lift and top-end GPS speed while keeping WOT RPM inside 5,500 – 6,000 RPM.